Durbar plating

A forum dedicated to workshop projects
Post Reply
Dave Noble
Fat Controller
Posts: 164
Joined: Mon Feb 27, 2006 12:38 am

Durbar plating

Post by Dave Noble » Tue Feb 13, 2018 9:41 am

I need some 5" gauge Durbar plating for a current project. Does anyone know where I can get any?

I tried the Tamiya stuff, nicely etched, but far too coarse.

If there is no current supplier, I can get some etched on 1/2mm nickel silver at £25 for a piece 300 x 150mm (plus carriage) if anyone else is interested.

Durbar.jpg
Durbar.jpg (28.96 KiB) Viewed 3691 times
Dave Noble
Fat Controller
Posts: 164
Joined: Mon Feb 27, 2006 12:38 am

Re: Durbar plating

Post by Dave Noble » Mon Mar 12, 2018 6:56 pm

As no-one seemed able to help, I've had some etched in stainless. It's soft soldered to the signal platform frame, and using phosphoric acid flux it tinned without any trouble at all. The bolt heads are 10BA.

P3110166.JPG
P3110166.JPG (89.63 KiB) Viewed 3626 times
Post Reply