Lion

A forum dedicated to workshop projects
Post Reply
User avatar
Scrat
Fat Controller
Posts: 97
Joined: Fri Feb 11, 2011 4:18 pm

Lion

Post by Scrat » Fri Jun 28, 2019 8:10 am

As some may have noticed, there is another wreck in my workshop for an overhaul.
This time it is a 5" gauge LION ti the Titfield Thunderbolt plans.
It is an unfinished, stripped model.
Some parts have been lost, others damages.

I already cleaned and painted the frames, worked on the cylinder block and now the first bits are coming together:

Yesterday I sealed the cylinder covers.
Broke one stud in the process.
It took a big pipe wrench to get the remaining bit out.
Fortunately the box-o-bits had a replacement.
All four cylinder covers are in place now. (Still have Hylomar on my fingers)

Then I installed the rockers:
Image

Image

The piston rods needed brass blocks to go into the forked end of the rockers.
Took a lot of filing to make them fit:
Image

Image

After fitting the front axle I can install the cylinder block between the frames.

Need to order more 4BA and 5BA nuts.

Decision has been taken not to use the LION nameplates but got for its sister loco TIGER.
So I will need new nameplates.
Does anyone know a manufacturer?
Peter Layfield
Porter
Posts: 9
Joined: Thu Sep 07, 2017 10:39 am

Re: Lion

Post by Peter Layfield » Sun Jul 07, 2019 8:29 am

I think Diane Carney has started producing plates again , she has a website
ejparrott
Cleaner
Posts: 10
Joined: Sat Jan 30, 2016 3:57 pm

Re: Lion

Post by ejparrott » Tue Jul 30, 2019 11:26 pm

Diane would be a good bet, but also Nick Elliott at Midland Loco Works.

Lion is a great engine for going and playing. Mine weighs all of 56lb! If you want to know anything let me know, mine is currently in bits while I do some rebuild on the chassis and fit a new boiler.
Post Reply