Hi folks,
work on the Claud is progressing. As some were based in Norwich (and I have a very good friend there) I am planning to get a matching shedplate for Norwich Shed (32A).
Which supplier would you suggest?
BEst regards
Holger
Suppliers of Shed Plates??
-
Richard Phillips
- Fat Controller
- Posts: 178
- Joined: Mon Feb 23, 2009 6:14 pm
Re: Suppliers of Shed Plates??
Peter took over from Bill Hall making locomotive and wagon plates.
http://www.petersplates.co.uk/petersplates/Home.html
Diane Carney makes good but expensive plates and my set (to my surprise) were not supplied cut and painted.
http://www.petersplates.co.uk/petersplates/Home.html
Diane Carney makes good but expensive plates and my set (to my surprise) were not supplied cut and painted.
Re: Suppliers of Shed Plates??
Scrat,
From your previous posts and from those I have seen on the LNER forum you have finished your very nice locomotive in GER livery (right or wrong) so it would not be correct to fit a 32A smokebox door shed plate, since this would be a post 1948 fitting associated with British Railways ownership.
I am not aware how GER displayed the shed allocation on it's locomotives, so I don't know how you would be able to show your model was a Norwich engine. If no one knows on this forum I'm sure there will be a positive response if you asked on the LNER site.
Eddie
From your previous posts and from those I have seen on the LNER forum you have finished your very nice locomotive in GER livery (right or wrong) so it would not be correct to fit a 32A smokebox door shed plate, since this would be a post 1948 fitting associated with British Railways ownership.
I am not aware how GER displayed the shed allocation on it's locomotives, so I don't know how you would be able to show your model was a Norwich engine. If no one knows on this forum I'm sure there will be a positive response if you asked on the LNER site.
Eddie